Shane’s Laser Cut Box

Today, I’m excited to share how I made a special 4″ by 4″ plywood box using a laser cutter, Adobe Illustrator, and a bit of patience. I’ll be honest about my experiences, both the successes and hiccups, and give tips on what I’d do differently next time. Let’s dive into this journey of making something unique!

Step 1: Getting the Materials

First things first, I used two pieces of thin plywood, each about 24″ by 24″. I got two in case I needed extra.

  • 1/4″ by 24″ by 24″ Plywood $7.28 each from Home Depot

Step 2: Designing with Adobe Illustrator

I first downloaded the box template from boxes.py, a website that made it easy to put in my desired measurements and quickly get a box design that is almost ready to be laser cut. I used Adobe Illustrator to create the design for my box by placing my college emblem on one side and my name on another to be etched onto the box. It took some time to make it look just right.

Step 3: Figuring Out the Laser Cutter

Now, this part got a bit tricky. I had to set up the laser cutter to etch my design onto the wood. I did this by changing the stroke to 0.072 pts and setting my speed to be 20%. But here’s where I messed up at first. There were several burn marks on my wood when I did the initial square inch test so I adjusted accordingly but I didn’t test the settings more comprehensively, and I ended up laser cutting onto one side of my box and it ended with some ugly burn marks. After my first not-so-great attempt, I tweaked the laser cutter settings carefully and tried again. This time, it worked! My design was etched onto the plywood, and it looked pretty cool. It took some patience, but I got there.

The next struggle was making sure the pieces fit together. I tested this by cutting out 2 pieces to see if they could connect to each other strongly without being loose. At first, the pieces were very loose and could not connect together so I played around with the settings and found that by adjusting the burn correction settings in boxes.py to 0.1mm, I was able to make the pieces connect sturdily. The final settings for my box were 18% speed, 100% power and 10% frequency.

Step 5: Putting the Box Together

With my pieces all cut out and ready, it was time to assemble the box.

Mistakes and How to Do Better Next Time

  • Burn Marks: My first try had burn marks because I rushed the settings. Next time, I’ll be more patient and test thoroughly.
  • Finding the correct burn correction settings.

Total Cost Breakdown:

  • Materials (Plywood): $14.56
  • Work Time (4 hours): $40.00

Total Project Cost: $50.00

Conclusion: Making a laser-cut plywood box was an adventure filled with ups and downs. I’ve learned that taking your time and testing things carefully is super important. Even though I faced some bumps in the road, I ended up with a unique box I’m proud of. So, if you’re thinking of trying something similar, remember that mistakes are part of the process, and each one helps you improve.

Print Friendly, PDF & Email