Laser Cut Box – with some mistakes

I have never used a laser cutter before, so this project was an interesting experience involving many mistakes.

I started with a few test cuts to find settings that would result in a raster that I was happy with. I ultimately settled on 20% power and 80% speed for the raster, with the vector cut using a frequency of 10, 5% speed, and 100% power. The result is shown below.

The next step was to find the value of kerf that would result in a box with the proper dimensions for a press-fit. My main mistake in this project was this step, as I opted to find the kerf by printing many test pieces to find a value that fits. This took more time and wood than necessary, although I eventually found the value I needed.

I would create new box sections with the generator using different kerf values, then put them all in one file with each box labeled so I could keep track.

Another mistake I made was that I had misunderstood exactly how the kerf value affected the part, so I wasted a few pieces by increasing the value instead of decreasing it. Eventually, I did figure out that for my set of conditions, a kerf value of 0.004 in allowed me to assemble the box where the finger joints could fit into each other.

Workspace before and after pictures:

Cost Breakdown:

Most of the cost in my calculation resulted from the labor costs, which were higher than expected due to my inefficient method of finding the proper kerf value.

Print Friendly, PDF & Email